2016-02-22, 16:26:14
Hi again,
and thank you very much for the quick response!
And the good news is, with your last hint I could sort out the problem.
I was conducting several test flights the last days with varying results on when FSXWX stopped injecting new stations and couldn't make sense of those. But your last hint (No 5) led to the solution -> it was all about my joystick...
When just leaving it alone during cruise I could see an ongoing jitter around the neutral position in the calibration tool. So to my understanding your tool interprets this as input, thus keeping it from injecting new stations.
The solution was quite easy then: I just unplug my joystick now during cruise and everything works well. (I did some testing with various settings for dead-zones, but none was convincing...)
So again, thank you for your help!!!
ps: I hope you can understand the tenor of my writing since I'm from Germany and my english is - well - a little rusty/poor :-)
and thank you very much for the quick response!
And the good news is, with your last hint I could sort out the problem.
I was conducting several test flights the last days with varying results on when FSXWX stopped injecting new stations and couldn't make sense of those. But your last hint (No 5) led to the solution -> it was all about my joystick...
When just leaving it alone during cruise I could see an ongoing jitter around the neutral position in the calibration tool. So to my understanding your tool interprets this as input, thus keeping it from injecting new stations.
The solution was quite easy then: I just unplug my joystick now during cruise and everything works well. (I did some testing with various settings for dead-zones, but none was convincing...)
So again, thank you for your help!!!
ps: I hope you can understand the tenor of my writing since I'm from Germany and my english is - well - a little rusty/poor :-)